Ricoh TH-C1b, Service Manual

Page: 210 / 433

10 February, 2005 SERVICE PROGRAM MODE
5-7
Service
Tables
1
Mode No.
(Class 1, 2, and 3)
Function / [ Setting ]
11 Heating: OHP/Full
Color
Sets the heating roller temperature for the OHP sheets
in full-color mode.
[120 ~ 190 /
175 / 1
°
C/step]
12 Heating: Duplex/1
Color
Sets the heating roller temperature for duplex printing
(both sides) in single-color mode.
[120 ~ 190 /
150 / 1
°
C/step]
13 Heating: Duplex/Full
Color
Sets the heating roller temperature for duplex printing
(both sides) in full-color mode.
[120 ~ 190 /
155 / 1
°
C/step]
14 Pressure: Idling Sets the temperature at which the pressure roller starts
idling.
[10 ~ 100 /
10 / 1
°
C/step]
15 Pressure: Ready Sets the temperature at which the pressure roller
becomes ready for printing.
[60 ~ 150 /
65 / 1
°
C/step]
16 Pressure: Standby Sets the pressure roller temperature for the ready
(standby) condition. After the main switch has been
turned on, the machine enters this condition when the
pressure roller temperature reaches the temperature
specified in this SP mode. When the machine is
recovering from energy saver or auto off mode, the
machine becomes ready when both heat and pressure
roller temperatures reach the specified temperature.
Heating roller: SP1-105-3
[60 ~ 150 /
115 / 1
°
C/step]
27 Heating: Sets the heating roller temperature correction for when
room temperature is 15
°
C or lower.
[0 ~ 20 / 5 / 1
°
C/step]
28 Pressure: Sets the pressure roller temperature correction for when
room temperature is 15
°
C or lower.
[0 ~ 20 / 0 / 1
°
C/step]
29 Heating: OFFSET – Sets the heating roller temperature correction for when
room temperature is 30
°
C or higher.
[0 ~ 20 / 5 / 1
°
C/step]
105*
30 Pressure: OFFSET – Sets the pressure roller temperature correction for when
room temperature is 30
°
C or higher.
[0 ~ 20 / 0 / 1
°
C/step]
Temperature Display
1 Heating Roller
106
2 Pressure Roller
Displays the current temperature of the heating and
pressure rollers.
Fusing Nip
1 Execute Mode Checks the fusing nip width using an OHP sheet.
•
The OHP sheet stops in the fusing unit for the
specified time (
SP1-109-2).
•
The nip width should be 9 ± 0.5 mm at front and rear.
If this requirement is not met, change the fusing unit.
109
2 Stop Duration Adjusts the stoppage time for the OHP sheet in the
fusing unit (
SP1-109-1).
[0 ~ 100 / 10 / 1 s/step]