8
The MP 6200AR Series
Only one jumper should be installed on the jumper connector. If
more than one jumper is installed, the drive may malfunction or be
damaged.
Master/Slave setting is determined by jumper installation on the Jumper
Connector. The following table shows the possible jumper settings.
Name
Function
MA
Drive set as Master (factory default)
(Master)
SL
Drive set as Slave
(Slave)
CS
Drive mode set by CSEL
(Cable Select) on the host IDE interface
A hard disk is normally installed as the Primary Master on the EIDE
(ATAPI) interface. Other EIDE peripheral devices such as hard drives
and CD-ROMs are then set differently.
Summary of Contents for MP6200A
Page 5: ...2 The MP 6200AR Series...
Page 19: ...16 The MP 6200AR Series...
Page 20: ...17 Section 2 Appendix Appendix...
