7
The MP 6200AR Series
4. Enhanced IDE
(EIDE/ATAPI) Setup
Before installation, set the jumper on the jumper connector on the rear panel.
The drive can be connected as the Master or Slave on an EIDE (ATAPI)
interface. When several (up to four) EIDE devices are connected, each must
be set in a unique way. Specific knowledge of hardware and software is
necessary to install the drive.
We cannot guaranty against direct or indirect damage resulting from im-
proper connections. Ask your supplier for details of the installation proce-
dure.
If two peripheral devices with the same settings are both connected
to the Primary or to the Secondary EIDE bus, the host computer may
fail to run, or may malfunction, so careful attention is necessary.
Make sure that the host computer is turned OFF when connecting
or removing a jumper.
Connect the jumper in the vertical direction as shown in Figure 1. If
connected horizontally as shown in Figure 2, the drive may mal-
function or be damaged.
Figure 1. (Master setting)
Figure 2.
CS: Cable Select
(CSEL)
SL: Slave
MA: Master
Summary of Contents for MP6200A
Page 5: ...2 The MP 6200AR Series...
Page 19: ...16 The MP 6200AR Series...
Page 20: ...17 Section 2 Appendix Appendix...
