10 October, 2002
PROGRAM DOWNLOAD
5-13
Service
Tables
5.2.2 RE-PROGRAMMING PROCEDURE AFTER DOWNLOAD
The following items need to be re-programmed after the software has download.
Re-Program Country Code
1. Press User Tools, #, 1, 9, 3 and then Start/Enter in sequence.
2. “MEMORY ALL CLEAR” will appear.
3. Press Start/Enter. The default country name will appear after “Select Country”.
4. Scroll through the countries by pressing “
◄
” or “
►
” repeatedly to find the
correct country code of each version:
•
EU version defaults to “UK” (see note 1 below)
•
NA version defaults to “USA” (see note 1 below)
•
Asia version defaults to “Singapore” except (see note 2 below)
NOTE:
1. Do not select any other country than the above listed.
2. In Malaysia and Vietnam, it is necessary to select these two country
codes. Also, it is necessary to select the country code in the
Philippines if the machine is using DP (dial pulse) mode.
5. Press Start/Enter to set the designated country code.
6. After “MEMORY CLEARING” and ‘beep’, the machine initializes and starts up.
7. As the machine memory is reset, re-program all necessary items. Refer to the
following.
Re-Program Settings and Data
1. Necessary items listed in System Data List. (
☛
5.1.2)
NOTE:
Though all counters are cleared, only the TOTAL TONER COUNTS
(toner dot counter) and CRU STATE can be re-programmed.
2. One-touch/Speed/Group dials
3. Ringer/On Hook Dial volumes
4. Receive mode
5.2.3 RECOVERY PROCEDURE
If the upgrade procedure fails during download, the machine freezes and stops
working. In this case, perform the following steps.
1. Turn the power off/on.
2. Repeat the steps in the download procedure from step 5.
The machine will start the upgrade process again.
