Ricoh K-C3, Service Manual

Page: 151 / 289

B245/B276/B277/B268/B269 Service Manual 18-Jan-06
142
Paper Feed Timing
1003*
Adjusts the amount of buckle the paper feed clutch applies to the paper after the
registration sensor is activated. A higher setting applies greater buckling.
1003 1 1st tray [0 ~ 10 /
5
/ 1 mm/step]
1003 2 2nd tray (B276/B277 only) [0 ~ 10 /
5
/ 1 mm/step]
1003 3 Optional tray [0 ~ 10 /
5
/ 1 mm/step]
1003 4 By-pass feed [0 ~ 10 /
6
/ 1 mm/step]
1003 5 Duplex
[0 ~ 20 /
6
/ 1 mm/step]
1007
Display By-pass
1007 1 Display By-pass Displays the by-pass paper width switch output.
Fusing Idling
1103*
This program decides the action of the Fusing Drive Release Mechanism. When
you select "1," the contact/release control is disabled and the drive power is
always transmitted to the fusing unit. As a result, the machine takes a longer
time to warm up the fusing unit. Use SP 1103 1 if fusing quality is low even when
the room temperature is not very low.
1103 1 Fusing Idling [
0 = No
/ 1 = Yes]
Fusing Temperature Adjustment
1105*
Adjusts the target fusing temperature. "Center" indicates the center of the roller;
"End" indicates the front and rear ends.
1105 1 Warm Up-Center
1105 2 Warm Up-End
[140 ~ 180 /
160
/ 1°C/step]
1105 3 Standby-Center [140 ~ 170 /
155
/ 1°C/step]
1105 4 Standby-End [140 ~ 165 /
150
/ 1°C/step]
1105 5 Copying-Center
1105 6 Copying-End
[140 ~ 185 /
160
/ 1°C/step]
1105 7 Low Level 2-Center
1105 8 Low Level 2-End
[0 ~ 80 /
60
/ 1°C/step]
1105 9 Thick-Center
1105 10 Thick-End
[140 ~ 185 /
175
/ 1°C/step]
1105 11 Warm Up Low-Center
[140 ~ 180 /
170
/ 1°C/step]