ENDORSER UNIT INSTALLATION
22 December 1998
3-6
3.4.3 STAMP DENSITY ADJUSTMENT PROCEDURE
1. Open the ADF cover [A]. Remove the
ADF upper cover [B] (2 screws), ADF
right cover [C] (1 screw), and the
endorser cover [D].
NOTE: Remove the right cover by
carefully lifting it from the rear.
2. Remove the solenoid assembly screw
[E] from the hole [F] and replace it in
hole [G]. Do not tighten the screw yet.
3. Loosen the screw [H] and adjust the
height of the bracket [I].
NOTE: To reduce the stamp density,
raise the bracket. To increase
the density, lower the bracket.
4. Tighten the assembly screw [E] to
secure the bracket in the new position.
5. Reinstall the endorser, right, and upper
covers.
G514I501.WMF
G514I507.WMF
[C]
[A]
[B]
[D]
[E]
[I]
[G]
[F]
[H]
