4
Take out the new imaging unit
from the black bag horizontally.
5
Put the used imaging unit into
the black bag horizontally not to
spill the toner.
❐
Do not shake the imaging unit to
the right or left.
6
Insert the trailing part of the im-
aging unit onto both hinges.
Then, put the other part of the
unit on the guide plate.
❐
Do not push the imaging unit. This
unit is set only to put it on the
guide plate.
❐
The imaging unit is shaky if you
push it — there is no problem.
7
Completely remove the tape
from inside the imaging unit by
pulling it out as shown.
❐
Hold down the unit with one hand
to avoid turning it over.
❐
Pull out the tape in the direction of
the arrow on the tape. After remov-
ing it, you will find the end mark at
the end of the tape.
W
HAT TO DO
IF
SOM
E
T
H
IN
G GOES
W
R
ONG
CHANGING THE IMAGING UNIT
35
Summary of Contents for FT2012+
