T
echnical
B
ulletin
PAGE: 9/11
Reissued:19-Oct-12
Model:
Booklet Finisher SR5040 (D512)/
Finisher SR5030(D513)
Date:
05-Jul-12
No.: RD512004a
4. Separate the base plate from the rear side plate by releasing the hooks on the base
plate from the slits on the rear side plate.
5. Install the washer in between the base plate and the side plate and hook it onto the
bottom screw hole that was loosened in step 3. Fasten the bottom screw added with
the washer.
NOTE: Make sure to support the base plate as you fasten the screw.
Make sure to hold onto the base
plate as you release its hooks from
the side plate.
The plates could be easily separated
by slightly widening the side plate
with your opposing hand.
The photo above shows the
base plate released from its
hooks.
Base plate
Hooks
Rear side plate
The washer is needed
only for the bottom
screw.
Add the washer
(0.5mm thick) in
between the base
plate and the side
plate.