T
echnical
B
ulletin
PAGE: 2/11
Reissued:19-Oct-12
Model:
Booklet Finisher SR5040 (D512)/
Finisher SR5030(D513)
Date:
05-Jul-12
No.: RD512004a
CAUSE
The front and rear supporting plates, which are bent and welded to the base plate, were
bent in incorrect dimensions due to a fault in the manufacturing process. This causes the
washer installed on the side plate to interfere with the side plate rail, stoppong the shift tray
from descending.
Occurrence Rate
No data available at RCL. However, the occurrence rate is expected to be low based on
the reports in Japan in which 4 units were found with the stated problem among 100
affected units.
Side plate
Washer
Side plate rail
Washer
Side
plate
Interference occurs here,
between the washer and the rail.
Base plate
Supporting plate: Front
Supporting plate: Rear
Incorrect dimension;
shorter than target
Side plate rail