No.
Component
Function
M9
Punch Movement Motor
Drives the front/back movement of the punch unit to position it
correctly for stapling the paper below.
M10
Stacking Sponge Roller
Motor
Rotates the stacking roller that drags each sheet back against the
end fence to jog the bottom of each sheet after feed out to the
upper tray.
M11
Fold Plate Motor
Drives the fold plate that pushes the center of the stack into the nip
of the fold rollers to start the fold.
M12
Fold Roller Motor
Rotates forward and drives the fold rollers that fold the stack and
feed it out of the fold unit, reverses to feed the fold once more into
the fold unit, and then rotates forward again to feed the fold out
of the fold unit.
M13
Corner Stapler Rotation
Motor
Swivels the corner stapler and positions it so the staple fires at an
oblique angle at the rear corner of the paper stack.
M14
Positioning Roller Motor
Drives the positioning roller in the stapling tray.
M15
Jogger Fence Motor
Drives the jogger fences in the stapling tray to jog both sides of
the stack before stapling.
M16
Fold Unit Bottom Fence Lift
Motor
Raises the bottom fence and stops when the center of the vertical
stack is opposite the edge of the horizontal fold blade. The dis-
tance for raising the blade is prescribed as one-half the size of the
paper selected for the job. For large paper, (A3, B4) the bottom
fence first lowers the stack 10 mm below the fold position, and
then raises it to the fold position.
M17
Stack Junction Gate Mo-
tor
Drives the large cam that operates the stack junction gate at the
top of the stapling tray. When this gate is open, it directs the as-
cending stack to the upper tray if it has been corner stapled, or if
it is closed the gate turns the booklet stapled stack down so it falls
onto the bottom fence of the folding unit.
M18
Shift Roller Motor
Drives the shift roller that operates in shift mode to stagger docu-
ment sets as they feed out to the upper tray (making them easier
to separate).
M19
Exit Guide Plate Motor
Drives the mechanism that raises and lowers the exit guide plate.
Component Layout
37
2
