Ricoh B079, Service Manual

Page: 764 / 948

BIT SWITCHES
B547 56 SM
3.2.3 PRINTER SWITCHES
Printer Switch 00 SP No. 1-103-001
No FUNCTION COMMENTS
0 Page separation mark
0: Disabled
1: Enabled
0: No marks are printed.
1 : If a received page has to be printed out on two
sheets, an asterisk inside square brackets is printed
at the bottom right hand corner of the first sheet,
and a “2” inside a small box is printed at the top right
hand corner of the second sheet. This helps the
user to identify pages that have been split.
1 Repetition of data when the
received page is longer than
the printer paper
0: Disabled
1: Enabled
0: The next page continues from where the previous
page left off.
1: The final few mm of the previous page are
repeated at the top of the next page. The amount of
repeated data depends on printer switch 04, bits 5
and 6.
2 Prints the date and time on
received fax messages
0: Disabled
1: Enabled
This switch is only effective when user parameter 02
- bit 2 (printing the received date and time on
received fax messages) is enabled.
1: The machine prints the received and printed date
and time at the bottom of each received page.
3-7 Not used Do not change the settings.
Printer Switch 01 SP No. 1-103-002
No FUNCTION COMMENTS
0-2 Not used Do not change the settings.
3-4 Maximum print width used in
the setup protocol
Bit 4 3 Setting
0 0 Not used
0 1 A3
1 0 B4
1 1 A4
These bits are only effective when bit 7 of printer
switch 01 is “1”.
5-6 Not used Do not change the settings.
7 Received message width
restriction in the protocol signal
to the sender
0: Disabled
1: Enabled
0: The machine informs the transmitting machine of
the print width depending on the paper size
available from the paper feed stations.
Refer to the table on the next page for how the
machine chooses the paper width used in the setup
protocol (NSF/DIS).
1: The machine informs the transmitting machine of
the fixed paper width which is specified by bits 3 and
4 above.