12
Revision 28
Step 6
– Fitting Mounting Plate & Motor:
•
Fit motor mounting plate back into place and fit and tighten anchor bolts (as per
figures 8 and 9).
•
Fit motor back on mounting plate, ensuring the power cord is positioned into the
end slot of the mounting plate in the direction of the power point, making sure
there are no pinch points (as per Fig 10).
•
Slide rubber grommet along the power cable and into the end slot of the mounting
plate (as per figures 11 and 12).
•
Bolt motor to the mounting plate using the M10 x 50mm bolts with spring and flat
washers provided and tighten as required (as per figure 13).
zz
Tighten bolts using
spanner or socket set
Fig 10
Fig 8
Fig 9
Fig 11
Mark anchor bolt positions
Fig 12
Fig 6
Fig 7
