15
Revision 28
Step 8
– Limit Travel Stops:
Included in your gate motor kit are two limit travel
stops (Part 6a) which must be fitted to the gear
racks on your gate to ensure safe operation.
The limit travel stops are designed to set the
desired opening and closing position of your
gate. These limit travel stops are designed to
come into contact with the spring limit switch.
Please note: gates can open and close in
different positions due to different weights of
gates, terrains, slopes (uphill or downhill). The
distance the gate will travel after contacting
the spring limit switch may vary.
Instructions on setting the limit travel stops can be found on the next page
The installation of spring limit switch block is shown in Figure 19
Fig 20
This diagram
shows the
gate in the
open position
Fig 19
Open Position
Limit Travel Stop
Closed Position
Limit Travel Stop
Fig 18
