8
3. Remove screw from the back of the base enclosure (see Figure 2-8). Slide the printhead to the far left
(home position) then remove the elec tron ics cover by lifting at back, tipping forward, and lifting over
print mech a nism.
4. If the print mechanism must be removed, turn the printer on its side and remove the 4 screws that
hold the print mech a nism to the bottom of the base enclosure (see Figure 2-9).
Print mechanism screws (4)
Figure 2-9. Bottom view of SP2200, showing screws for removing print mechanism
5. Set the printer upright, then remove the print mechanism. Do not disconnect cables between the print
mechanism and the SP2200 circuit board.
Replugging cables into the wrong connectors will result
in circuit damage.
Once the print mechanism has been removed from the base enclosure, all of the circuit board sockets, jump-
ers, and connectors can be easily accessed. Figure 2-10 shows the locations of these components on the circuit
board. Continue with the procedure for the particular option you want to install.
