Rice Lake IQ plus 2100, Installation Manual

Page: 36 / 43

EDP Commands 31
Current configuration parameter settings can be displayed in either setup mode or normal mode using the following
syntax:
command <ENTER>
Most parameter values only can be changed in setup mode. Use the following command syntax when changing
parameter values:
command = value <ENTER>
where
value
is a number or a parameter value. Use no spaces before or after the equal (=) sign. If you type an
incorrect command or value, the display reads
??
. Changes to the parameters are saved as they are entered but
typically do not take effect until you exit setup mode.
For example, to set the motion band parameter to 5, type the following:
MOTBAND = 5D <ENTER>
Command Description Values
GRADS Graduations 1–10 000
ZTRKBND Zero track band OFF, 0.5D, 1D, 3D
ZRANGE Zero range 1.9%, 100%
MOTBAND Motion band 1D, 2D, 3D, 5D, 10D, 20D, OFF
OVRLOAD Overload FS+2%, FS+1D, FS+9D, FS
FILTER Digital filtering 1, 2, 4, 8, 16, 4RT, 8RT, 16RT
Table 5-3. CONFIG EDP Commands
Command Description Values
PRI.DECPNT Primary units decimal position 8.88888, 88.8888, 888.888, 8888.88, 88888.8, 888888, 888880
(88 88.8 or 888 88 in LB/OZ display mode)
PRI.DSPDIV Primary units display divisions 1D, 2D, 5D
PRI.UNITS Primary units LB, KG, OZ, G, LB/OZ
ALT.LB
ALT.KG
ALT.OZ
ALT.G
ALT.LBOZ Enable alternate units ON, OFF
Table 5-4. FORMAT EDP Commands
Command Description Values
WZERO Zero calibration —
WVAL Test weight value test_weight_value
WSPAN Span calibration —
REZERO Rezero —
LC.CD Set deadload count value
LC.CW Set span count value
Table 5-5. CALIBR EDP Commands
Command Description Values
EDP.BAUD Serial port baud rate 1200, 2400, 4800, 9600
EDP.BITS Serial port data bits/parity 8NONE, 7EVEN, 7ODD
EDP.TERMIN Serial port termination character CR/LF, CR
EDP.ECHO Serial port echo command OFF, ON
PRNFREQ Print frequency DEMAND, AUTO1, AUTO2, STREAM
Table 5-6. SERIAL EDP Commands