38
DC-100 Operation Manual
Notes:
•There are four types of setpoints which can be selected by rotating through them in the following order using the [+}
key: % of Quantity (%QTY), % of Weight (%WT), Over/Under Quantity (QTY), or Over/Under Weight (WT).
• When entering weight setpoints, be sure that you enter in the weight values with decimal point and all leading and
trailing zeros.
• All percentage values must be rounded to the nearest whole number, fractional percentages are not allowed.
• Setpoints involving % of quantity or weight are limited by the decimal places available on the display. For example: if
Set Point value 1 specifies a Quantity of 9999999, then a Set Point value 2 of % of Quantity cannot be set for more than
100% because all 7 digits of the display are already in use.
Table 6-3 below shows what to enter in each of the two set point values to program each type of set point. The alarm
sounds with a rhythmic beeping at setpoint one and with a rapid beeping at setpoint two. For the Setpoint buzzer to be
activated, SPEC 10: SET POINT BUZZER must be set to “0: BUZZER ON”. See Section 3.1.1 for setting spec codes.
Here are some examples of how the setpoints can be programmed. These examples can be adjusted to fit your
application.
13. Use the
<<
and
>>
keys to choose what type of setpoint value you want to enter. Enter the first setpoint
value. Press the
* REPRINT
key to store the setpoint.
14. Repeat Step 13 for the second setpoint value. Press the
* REPRINT
key to store each setpoint value after
entering it.
15. The DC-100 does not use address numbers on its label format so you can press the
* REPRINT
key to
move to the last step.
16. Press the
CODE
key to save all the data you have entered associated with this item or press the
MODE
key
to exit without saving the data.
17. Press the
MODE
key three times to exit the programming mode and return to the stand-by screen.
% QTY
QTY
% WEIGHT
WT
Program Set Point 1 value with . . .
target quantity
low value
target weight
low value
Program Set Point 2 value with . . .
% of quantity
target value
% of weight
target value
Table 6-3. Setpoint Configuration
Setpoint Types
% QTY
QTY
% WEIGHT
WT
Setpoint 1
80 pieces (target)
50 pieces
2.0 lb (target)
1.2 lb
Setpoint 2
80%
75 pieces (target)
50%
1.5 lb (target)
Equation
80 x 80% = 64
N/A
2.0 x 50% = 1.0
N/A
Slow Beeping Occurs At
64 pieces
50 pieces
1.0 lb
1.2 lb
Rapid Beeping Occurs At
80 pieces
75 pieces
2.0 lb
1.5 lb
Table 6-4. Setpoint Examples
All manuals and user guides at all-guides.com
