Rice Lake 482-AG, Technical Manual

Page: 49 / 60

EDP Commands
© Rice Lake Weighing Systems ● All Rights Reserved 45
6.1.5 Weigh Mode Commands
The serial transmit weight data commands in Table 6-10 transmit data to the selected port on demand. The SX and EX
commands are valid only in the weigh mode; all other commands are valid in either configuration or weigh modes.
Command Description Values
POWER Determines if indicator automatically powers on when plugged in or if power key
must be pressed. Read only in weigh mode.
AUTO
MANUAL
BKLGHT Controls the LCD backlight display.
Read only in weigh mode.
ON, OFF, AUTO
BKLGHT.AUTO Controls the LCD backlight display auto off time.
Read only in weigh mode.
10SEC, 30SEC, 1MIN, 5MIN, 10MIN
BAT Reads the battery level. Read only. Current battery level in millivolts.
Table 6-9. MISC Commands
Command Description Response Format
UID View and set unit ID when in configuration
In weigh mode, the value can be changed temporarily; it will reverts to
last saved value at next power up
nnnnnn
DATESET View or set date The response will be in the format, and using the separators, as
defined in configuration; to set, first query the date, then send
DATESET= , in exactly the same format (use only two digits for
the year)
TIMESET View or set time The response will be in the format, and using the separators, as
defined in configuration; to set, first query the time, then send
TIMESET= followed by the time in exactly the same format as
the query, including seconds, and AM or PM if in 12 hour format
SX Start streaming on Port 2.
NOTE: The trigger mode of Port 2 must be set to one of the
five stream s for this command to function.
OK or ??
EX Stop streaming on Port 2
NOTE: The trigger mode of Port 2 must be set to one of the
five stream s for this command to function.
OK or ??
RS Soft reboot See Section 6.1.3 on page 42
XG Transmit gross weight in displayed units nnnnnn UU
Where nnnnnn is the weight value, UU is the units
XG2 Transmit gross weight in non-displayed units
XE Query system error conditions nnnnn nnnnn
See Section 8.1 on page 48 for detailed information about the
XE command response format
Table 6-10. Weigh Mode EDP Commands