4
A
A
DANGER:
ELECTROCUTION
OR ELECTRICAL SHOCK RISK.
DISCONNECT ELECTRICITY BEFORE
WORKING ON PUMP, OR SHOCK, BURN
OR ELECTROCUTION CAN RESULT.
Always disconnect pool pump power at the circuit breaker
before servicing the pump. Death or serious injury to
service people, pool users or others due to electric shock
could result from failure to avoid the high danger risk.
A
A
DANGER:
For continued protection against possible
electrical shock, this unit is to be mounted to the base in
accordance with the installation instructions.
NOTE:
Always turn off all power to the pool pump before
installing the cover or working on any suction outlet.
NOTE:
This pump operates with electrical voltage, and
can generate both vacuum and pressure in the water
system. When properly wired and plumbed, this pump
will operate in a safe manner.
A
A
WARNING:
Do not bury the electrical cord. Place
the cord so as to eliminate contact to from lawnmowers,
hedge trimmers, other equipment and to avoid a tripping
hazard.
A
A
CAUTION:
This pump is for use with permanently
installed pools and may also be used with hot tubs and
spas. Do not use with storable pools unless the pump
is protected by a factory installed double insulated
enclosure. A permanently installed pool is constructed
in or on the ground or in a building such that it cannot
be readily disassembled for storage. A storable pool is
constructed so that it may be readily disassembled for
storage and reassembled to original integrity.
A
A
WARNING:
To reduce the risk of electrical shock,
connect ground wires to grounding screw located in the
motor. Use no smaller than a #12 AWG (3.3 mm) wire.
A
A
WARNING:
To reduce the risk of electrical shock,
replace any damaged electrical cord immediately.
A
A
WARNING:
Never work on the pump while it is
running or the power is still connected. High voltage
can cause serious or fatal injury. A suitable ground
fault interrupter (GFCI) should always be installed at
the power supply source of this unit. Article 681-31 of
the NEC requires that a GFCI be used if this pump is
used with a storage pool. Be sure to ground the motor
before connecting to electrical AC power source. Failure
to ground the motor can cause serious or fatal electrical
shock hazard. DO NOT ground to a gas supply pipe line.
A
A
WARNING:
Ground and bond the pump before
connecting to electrical power supply. Failure to ground
and bond the pump can cause serious or fatal electrical
shock hazard. DO NOT ground to a gas supply line. To
avoid dangerous or fatal electrical shock, turn OFF power
to the pump before working on electrical connections.
NOTE:
Always turn off all power to the pool pump before
installing the cover or working on any suction outlet.
A
A
CAUTION:
Elevated water temperature can
be hazardous. The U.S. Consumer Product Safety
Commission has these guidelines:
1.
Spa water temperatures should never exceed 104°F
(40°C). A temperature of 100°F (38°C) is considered
safe for a healthy adult. Special caution is suggested
for young children.
2.
Drinking of alcoholic beverages before or during spa
or hot tub use can cause drowsiness which could
lead to unconsciousness and subsequently result in
drowning.
3.
Pregnant Women Beware! Soaking in water over
102°F (39°C) can cause fetal damage during the first
three months of pregnancy resulting in the birth of a
brain-damaged or deformed child.
4.
Before entering the spa or hot tub, users should
check the water temperature with an accurate
thermometer; spa or hot tub thermostats may err
in regulating water temperatures by as much as 4°F
(2.2°C).
5.
Persons with a medical history of heart disease,
circulatory problems, diabetes, or blood pressure
problems should obtain a physician’s advice before
using pools or hot tubs.
6.
Persons taking medications which induce
drowsiness, such as tranquilizers, antihistamines,
or anticoagulants, should not use spas or hot tubs.
CONTROLLED COPY approved for factory use on 4/16/2020. RAYPAK PROPRIETARY AND CONFIDENTIAL INFORMATION . Approval signatures on file in Engineering.
