10
Figure 3-4.
Cylinder, Main Frame and Leg Assembly
(Figure shown without hoses for clarity)
3.7
MAIN FRAME AND LEG ASSEMBLY
1.
Refer to Figure 3-4.
Install left side main frame (4) and right side main frame (5) onto each leg assembly. Set left and
right frames to a dimension of 37-1/2” inside frame as shown (XX) on figure 3-4.
2.
Secure the left and right side frames to the leg assemblies using hardware E, F, G, & H.
3.8
ALUMINIM BUNK ASSEMBLY
WARNING:
DO NOT ALLOW ANYONE TO OPERATE THE POWER SUPPLY WHILE INSTALLING THE
BUNKS. THIS CAN CAUSE PERSONAL INJURY AND/OR EQUIPMENT DAMAGE.
1.
Refer to Figure 3-5.
Install aluminum bunk (12) to the lift arms. Place the bunk so that the sloped top surface is toward
the inside of the lift.
2.
Insert clevis pin (K) through one side of the aluminum bunk. Insert nylon washer (O) between bunk and the lift arm.
Finish inserting clevis pin through the lift arm. Insert another nylon washer (O) between the bunk and other side of lift
arm before fully inserting clevis pin. Repeat for other end of bunk.
3.
Install flat washer (R) and cotter pin (P) on each end of clevis pin (K). Secure clevis pin by spreading end of cotter pin
apart and bending around clevis pin. Repeat for other end of bunk.
4.
Repeat steps 1 thru 3 to assemble other bunk.
