16
4.
If the solar panel does not keep the battery charged, try any of the following:
a.
Move the solar panel to an area with less obstructed sunlight.
b.
Add a second solar panel, or add an AC charger.
c.
Booster charge the battery at mid season.
5.
Check water level in battery every three months. If the water level is low, fill it up with distilled water. Booster charge
the battery with a 2A charge using a 10A charger in the beginning and end of the season.
5.3
REMOTE CONTROL INFORMATION
The remote transmitter can de-program due to either a power loss (dead battery) or electrical interference, which will require
re-programming of the transmitter.
Proper function of the RC system is dependent upon several factors that are not controllable by the manufacturer. RGC is not
responsible for the following: Improper installation, Low battery, Natural occurrences, Use other than intended, Location of
panel, receiver or transmitter too close to interfering metal objects, Multiple RC panels within 15 feet of each other, Use in
area with external interference such as radio, cell phone, and TV towers or a natural magnetic field, Blocked or shielded
antenna, Other transmitter interference from cell phones, cordless phones, wireless systems, CB and mobile transmitters,
computer and industrial equipment, electric motors, even fluorescent lights.
Reprogramming Your Remote Control
In the event that you may need to reprogram your remote control unit, please follow these step instructions:
1.
Hold down both the red button (located on the black RC box) and the “UP” button (located on the hand held remote) at
the same time for five (5) seconds.
Note: If black box does not have red button on the outside use the next procedure below.
2.
Release “RED” button (located on the black RC box) and continue to hold down the “UP” button (located on the hand
held remote) for an additional five (5) seconds.
-OR-
1.
Remove cover from black RC box. A see-through cover control unit is inside this box. Hold down “black” button
(located on the side of the see-through control unit) until red light flashes once in the see-through control unit located in
corner.
2.
Release the “black” button then hold down the “UP” button (located on the hand held remote) for five (5) seconds.
You may have to repeat these two (2) steps more than once to reset your remote control unit.
