VSP 5360 User Manual
61
Chapter 6 Support
6.1 Questions and Troubleshooting
6.1.1 No Output in LED Display
Frequently Asked
Question
No output in LED Display
Troubleshooting
Confirm If There is Any Input Signal
Check whether the input signal is normal, if normal, check the front-end
signal lines, and please note to do dual display or extended in computer .
User can enter other format signals to view in the same operation.
Confirm If Signal Output
Find a belt VGA input (best for DVI) display, connect to the corresponding
output port of processor, and check whether the signal is correct on the
monitor. If not display properly, please check whether there is input signal,
or if input wire interface is taken tight, output wire interface is picked up
tightly. If display normally, check if sending card is normally working or need
to replace sending card test.
6.1.2 Flash Point in LED Display Output
Frequently Asked
Question
Flash point in LED display output
Troubleshooting
Confirm If Monitor Output is Normal
Find a belt VGA input (best for DVI) display, connect to the corresponding
output port of processor, and check whether the signal is correct on the
monitor. If display normally shows and no flash point, please check whether
DVI outlets put tight or replace to DVI line of sending card. If display flashes
point, please judge if input signal, wire, and interface are normal.
6.1.3 LED Display Only Displays part of the Image
Frequently Asked
Question
LED Display only displays part of the image
Troubleshooting
Scale the Image
Push [Scale/Position]
button in the processor and knob to adjust the actual
screen size of the screen, including “H Size”, “V Size”, “H Pos”, “V Pos” and
