14 |
P a g e
RF MOGUL 3604 South Via Terra Salt Lake City, Utah 84115 Sales: 801-895-3392 Email:
A.
Antenna Control Cable Connection. Snap together Male (33482-1201 Molex) Antenna Side and
Female (33472-1201 Molex) Control Cable to ACU-1 Antenna Controller.
B.
RX/TX Cable to HT2000 Modem. RG-6 Coax Cable.
16)
Secure the cable wires with cable clamps every 10-12 inches from the antenna junction box working
towards the cable entry hole into the vehicle.
17)
Coat all cable clamps and screws with Dicor to prevent water leakage.
18)
Put
silicone
in the cable hole (
NOT
Dicor as it is self-leveling and will seep into the hole) to fill the
void and help prevent water penetration. Once the silicone has set use the Dicor around the silicone
to water seal the cable penetration area.
19)
Pull any excess cables through the pass-through entry hole and then screw the Clam Shell cover
over the hole. This will prevent water entry. Cover the outer seam of the cover and all screws with
Dicor.
Caution: It is advisable to place the open end of the Clam Shell towards the rear end
of the vehicle to prevent pressure on the opening while driving.
20)
Cut
your Control and Coax cables to length inside the vehicle. Insert the cables into split loom cable
wrap. Leave enough length of both cables to be able to remove the ACU-1 Controller from the
cabinet with ease should the occasion arise. Wrap excess cable into a coil and secure to the back of
the cabinet.
21)
Securely
fasten
the electronics into the selected storage location to prevent damage during travel.
Attach all cables in accordance with your diagramed instructions. (shown on Page 16)
Double check
all
electrical and coax connections from the controller to the mount and transceiver
BEFORE applying power.
DO NOT stack electronic equipment as it will cause excessive heat buildup and potentially cause
damage to some or all equipment.
