20 |
P a g e
RF MOGUL 3604 South Via Terra Salt Lake City, Utah 84115 Sales: 801-895-3392 Email:
This document was created using a Router and setting the Modem into the WAN Port.
If using a Switch, follow setup instructions below.
Leave the Modem, PC and Satellite Antenna Controller connected to the Switch.
To change this, you will need to:
•
Set PC IP Address to 192.168.10.10
•
Open NETWORK SETTINGS page
•
Change Controller IP Address to 192.168.0.250
•
Change Gateway to 192.168.0.1
Update Settings:
•
Set PC IP Address to 192.168.0.10
•
Set PC Subnet to 255.255.255.0
•
Set PC Gateway to 192.168.0.1
Update and Close
Cycle power to Modem and Controller
Wait 2+ minutes for Modem to reset and come up
•
Open Controller using IP address 192.168.0.250
•
Open Modem Status Page and check for Modem Information
o
This make take several minutes.
•
If no connection check that Search Settings Modem IP is 192.168.0.1
Stowing the system for travel
1)
Press the stow button on the front panel of the Satellite Antenna Controller.
2)
Verify the system is stowed by physically inspecting it.
Caution: It is critical to physically inspect your antenna dish prior to moving the
vehicle as traveling with the dish up will result in destruction of the antenna.
