12 |
P a g e
RF MOGUL 3604 South Via Terra Salt Lake City, Utah 84115 Sales: 801-895-3392 Email:
8)
Put Dicor sealer over the locations of the predrilled holes on the mounting feet or the predrilled
holes on the mounting plate.
9)
Lift the antenna over the location where the antenna screws will penetrate the mounting surface
(including any extra drilled screw locations) and lower the antenna mount feet/plate onto the
mounting surface.
10)
Secure the mount feet/plate to the roof using the mounting screws you selected.
11)
Liberally coat the screw heads and around the mount feet/plate with Dicor to prevent water
penetration, as shown below.
12)
Install the Transceiver Landing plate (if not installing a Mount Plate Option) where the Transceiver
Arms and transceiver will stow on the roof (Approximately 10-12 inches in front of the antenna
base) with screws. (Use the photo in step 13 as a reference) Dicor around the plate and on the screw
heads.
13)
Using a small diameter drill bit make a small pilot hole in the roof where the cabling will pass
through into the control cabinet in the vehicle.
14)
Drill the larger 1-inch hole using the 1-inch drill bit or hole saw.
Pass through into
vehicle with the
Clam shell
to
cover the entry
hole.
Weather Cover
junction box is
to protect cable
connections.
Service loop
allows future
cable repairs.
Transceiver
Landing
Plate
Reflector facing to
the rear of Vehicle
when installing!
Feet Mount Option
Plate Mount Option
