17040952—ENG
7/12
Restart
:
The function
"Restart", serves to
reconfigure the
chronothermostat
in the case has
been made an
intervention
hardware or software in the control board of the
generator. Activate the reconnection is equivalent to
physically disconnect the communications connector
from the chronothermostat and then reinsert it.
OFFSET
: In the submenu "Write SA Offset" you can
set an offset value to give to the room temperature
setpoint for each slave.
This can be useful when the hot air generators are
installed in places colder or warmer than the point
where the chronothermostat is installed. It can be
useful to overcome the problems of stratification of
the ambient temperature.
There are
shown a
number of
offsets equal to
the number of
slaves
connected up
to a maximum of 10 slaves.
For example, looking at the image above and offsets
set, if the room temperature set in one of the
following operating modes automatic, manual,
overtime is 22 ° C, then the slave working setpoint is
for slave 1 22°C+9°C=31°C, for slave 2
22°C+5°C=27°C and so on.
We emphasize that at calculate the level of power in
relation to the set room temperature and measured
are the electronic control units of the slaves.
Read
slave
: The last item "Read Slave" of the
"PARAMETERS MENU" you can view the percentage
the value of the respective temperature probe of
power, and the LC1 temperature of hot air
generators.
You are shown a
number of rows
corresponding to
the number of
slaves connected
up to a maximum
of 10 slaves.
In addition pushing from the main screen,
simultaneously the
buttons 5 and 6
shown below, in
any operating
mode, even with
key lockout on, you
can display the
"Read Slave".
If Kronos GA11 is connected to the electronic control
unit REG_ROB instead of to the electronic control
unit TC340, the information displayed in the "Read
Slave" vary as shown below.
In the "Read Slave" in this case is displays the operating
status and the probe value of their connected slaves.
Also are displayed a number of rows corresponding to
the number of slaves connected up to a maximum of 10
slaves.
SPECIFIC FUNCTION - KEYLOCK AND PASSWORD
To avoid that accidentally pushed buttons go to change
configuration settings, in one of four operating modes
except
mode
"overtime",
after 1
minute of
operation
without
having
pushing
any
button, you activate the keys lockout.
To proceed with unlocking a password is required. The
password to unlock the keys is 13.
Reset unlock is always enabled with the keys lockout
activated. So, you can send a reset to the control unit of
air generators without having to enter the password and
unlock the keys.
