REX MANTIS 120A, Operation Manual

Page: 16 / 23

Fig. 29
XB125 Chain Vice
(Fig. 27, Fig. 28)
XB120A Flat Vice
(Fig. 27, Fig. 29)
Hold the handle and raise the frame to its highest point,
making
sure the stopper is engaged(Fig. 27).
Turn the vice knob anti-clockwise and release the lock
(Fig. 29).
Pull the vice knob and remove the workpiece
(Fig. 29).
Remove workpiece
Unlock
Pull out vice knob
Flat Vice
Cutting
3. What to do if the motor stops
(Fig.26)
・
If an excessive load is applied during cutting or if the
blade gets caught in the workpiece and locks, the overload
protection unit will be activated and the motor will stop.
If the overload protection unit has been activated, reset the
unit as follows:
(1) Set the ON/OFF switch to the "OFF" position.
(2) Eliminate the cause.
(3) Press the RESET button below the ON/OFF switch (Fig. 26).
Note: If the motor has overheated, it may not be possible to reset
the unit immediately . In such a case, wait a few minutes and then
press the RESET button again.
4. Removing the Workpiece
(Figs.27 - 29)
(1) Hold the handle and lift the frame to its highest point. Check to
make sure the frame has been stopped by the stopper (Fig . 27).
(2) Turn the chain lock knob counter -clockwise to unlock the
chain (Fig. 27).
(3) Unhook the chain handle hook from the base (Fig. 28).
(4) The chain will be coiled automatically by the autocoil
mechanism (Fig. 28).
(5) Remove the workpiece (Fig. 28).
Overload
protection unit RESET button
Fig. 26
Fig. 27
Fig. 28
Handle
(1) Lift
frame
Chain lock knob
(2) Unlock
(5) Remove workpiece
(4)
(3) Remove
from hook
- 13 -
Chain Vice