REX MANTIS 120A, Operation Manual

Page: 13 / 23

1. Adjusting the Cutting Load (Fig. 14)
Referring to the table on Page 5, adjust the cutting load to match
the material being cut.
(1) Lift up the frame to its highest point.
(2) Pull the load adjustment knob while turning it, and set it to a
load setting that matches the material to be cut.
(3) Slowly lower the frame.
Note: The frame stopper may be disengaged, so lower the
frame carefully .
is not fastened securely in place, cutting will be unstable,
resulting in damage to the machine or in accident or injury.
.
CAUTION
1. Preparing for Cutting
(Fig.14)
2. Clamping the Workpiece
(Figs. 15 - 22)
(1) Lift
(2) Pull load
adjustment knob
while turning it
LL = Ultra-light load
L = Light load
M = Medium load
H = Heavy load
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Chain handle
(1) Chain lock knob
(2)
(4)
(5)
(3) Place workpiece
Chain handle
Chain lock knob
Pr eparing for Cutting
- 10 -
XB125 Chain Vice
(Figs. 15 〜 17 ）
(1) Turn the chain lock knob anti-clockwise and release the
chain lock (Fig. 15)
(2) Unhook the chain handle and place at the rear of the vice.
(Fig. 15)
(3) Place the workpiece in the V-shaped groove on the vice.
(Fig. 16)
Note: For longer workpieces place one end on a support.
(4) Pull the chain handle back over the workpiece and hook to
the base of the vice (Fig. 16)
Note: If you cannot pull the chain out properly, turn the chain lock
knob anti-clockwise to release the lock.
(5) Turn the chain lock knob clockwise to tighten the chain
(Fig. 17)
Chain Vice
Make sure the workpiece is clamped securely. If the workpiece