Revv Owner’s Manual - 26
Note: There are only 4 LEDs that illuminate in the process, so the MIDI
channel count will be done in values of 4. MIDI channel 1 will be signified
by Channel LED flashing, & as you increase in number, MIDI channel 4 will
be signified by all 4 LEDs flashing, but once MIDI channel 5 is selected,
only the Channel LED will flash again. Every time you reach MIDI channel
5, 9, or 13, the LED cycle will once again. So keep count as you select the
channel you desire. If you go past MIDI channel 16, the count will start at
channel 1 again.
Once saved to memory, the Channel LEDs will flash very quickly a
number of times to verify the change has been made & completed. The
amp will then restart, completing the MIDI channel change procedure.
MIDI Program Change
This amplifier can remember up to 128 program settings of the MIDI con-
trollable functions. In order to set a program (i.e. amplifier configuration) to
be controlled via MIDI:
1)
Set the amplifier to the configuration you intend to save to a program
number. (Ex: Ch: 2, Dynamic level: 2, FX Loop: OFF, etc)
2)
Once the amplifier is configured as you would like, press and hold the
bright switch. The bright LED will flash & the amplifier will wait now for a
command through its MIDI IN jack.
3)
Send a program change command from your MIDI Pedal or other
equipment with the correct channel & program number you intend to
have the amplifier save the current configuration to.
4)
Once the command is received, the amplifier will save the current amp
configuration to that program number. The bright LED will flash 3 times &
turn off verifying that the command has been received & saved.
6.3
