24
25
g Press the Body Pads on the area you wish to apply
electrical stimulation to, as shown on page 23, gently
pressing the adhesive side against the skin.
h Press the power button on the device or on the remote
control to turn Revitive on.
You will hear a beep and the display lights will light up.
The time will read 30 minutes, the Intensity will
read 00 and the EMS symbol will be displayed.
Revitive Body Pads will automatically provide stimulation in
EMS mode.
If you wish to use Revitive Body Pads in TENS Mode press
the TENS button on the remote control.
You will then see the TENS symbol on the display.
See page 27 for further instructions on how to switch
between EMS and TENS mode.
i Set the time for Revitive. The default time is 30
minutes. You can set the timer for up to 60 minutes
If you do not want to use the default time of 30 minutes,
set the time for the number of minutes you want.
You can use the controls on the control panel or on the
remote control.
Press the (+) Time Control to increase the time.
Press the (–) Time Control to decrease the time.
0
3o
0
0
3o
0
0
0
3o
Instructions for use
b Clean and dry the area where you will place the Body
Pads.
c Make sure Revitive is switched off. If the control panel
is still illuminated, press the power button and turn
Revitive off.
d Attach the ends of the Body Pads to the Electrode cord.
Press connectors until there is no gap between them.
Leaving a gap may cause discomfort or no stimulation.
e Plug the other end of the Electrode cord into the
socket on the side of Revitive.
Plugging in the Electrode cord will automatically
turn the foot-pads off.
f Remove the plastic liner from the Body Pads, by peeling it
off carefully. Replace the Body Pads onto the plastic liner
after use.
5603_IFU02_17807098.indd 24-25
5603_IFU02_17807098.indd 24-25
12/01/2021 08:53
12/01/2021 08:53
