20
21
j
If you remove one or both feet from the foot-pads, Revitive will pause the
stimulation for up to 10 minutes. The display will blink on and off and you
will hear a beep. The timer will stop until the session is resumed. Do not
touch the foot-pads with your hands or pick up device until paused is enabled
The stimulation can be resumed by placing both feet back on the foot-pads and
then pressing the (+) button on the Intensity Control.
While Revitive is paused, the intensity level can be reduced by pressing the
(–) button on the Intensity Control.
Intensity cannot be increased while Revitive is paused.
After 10 minutes of being in the paused state, Revitive will switch itself off.
k
The Time Display will start to count down in minutes as Revitive cycles
through its program.
l
When Revitive times out, the Time Display reads 00 and you will hear
three beeps.
m
Revitive switches itself off automatically.
Instructions for use
g Press the (+) Intensity Control one time to
start stimulation.
You can use the buttons on the control panel or
remote control. Ensure both feet are on the foot-
pads when increasing the intensity.
Press the (+) button to increase the level.
Press the (–) button to decrease the level.
70
3o
h
Ensure you familiarise yourself with the feeling of the Medic Program. Use on a low
intensity for 30-60 minutes once per day for a few days.
Set the intensity at a level where you can feel the stimulation in your feet which
creates a calf muscle contraction.
It is normal to feel tingling or varying sensations in your feet and calf muscles.
Revitive does
not vibrate.
i After a few days of familiarisation, use a higher intensity that provides you with
strong but comfortable calf muscle contractions.
Most people experience a strong contraction at intensity level 40 or over.
The IsoRocker® enables Revitive to rock up and down once muscle contractions are
nearing the desired level. The rocking is caused by muscle contractions in the leg,
and the resulting ankle movement allowed by the IsoRocker is a good indicator
that the intensity level is sufficient to provide the therapy. Increasing the intensity
above this level will enhance the therapy, but should not be allowed to become
uncomfortable.
You can set the intensity between 1-99.
Please note that the intensity required may vary from day to day.
If you feel pain or discomfort:
• Remove one or both feet from the foot-pads to stop the stimulation
• Lower the intensity of the foot-pads using the (–) Intensity Control on
the control panel, or remote control, before replacing your feet on Revitive
5603_IFU02_17807098.indd 20-21
5603_IFU02_17807098.indd 20-21
12/01/2021 08:53
12/01/2021 08:53
