FOB Mode
FOB (Foam On Beer) refers to foam explosion. When the KEG is almost empty, only beer
foam is left in the KEG, and this foam will explosively come out of the dispenser. If users
activate FOB mode, this beer foam explosion can be prevented.
• On/Off : You can press Up and Down button to set the Mode
• Flow rate coefficient : You can change the value using Up and Down button
(Default value : 1.30)
• Meaning of Flow rate x 1.30 : FOB Mode will be activated when the speed of beer flow
becomes faster than 1.3 times of normal Flow rate
(Normal Flow rate is detected and memorized when Sync Mode is activated)
(Beer flow becomes faster when beer is dispensed together with foam)
• When the FOB Mode is activated, the below display will show up and stop dispensing
• Step-by-step procedure to replace with the new KEG
1) Check the KEG whether it is empty or not (Shake the KEG)
2) If it is empty, you need to change the KEG with the new one
3) Press Stop button to turn off FOB mode
4) Close the middle valve of CO2 tank and replace the KEG with the new one
5) If you dispense a few cups of beer with the new KEG, those beer foam remaining in
the cooler and the tube will come out. 2-3 cups will be enough to remove all the
remaining foam
6) Once the foam is cleared, go to Mode Setting and turn on the FOB mode again
• If FOB Mode is activated even when the KEG is not empty, follow the below steps
1) Execute the Sync Mode to reset the flow rate of the dispenser
2) If FOB Mode is activated again even though the beer is not empty after Sync Mode
execution, change the flow rate coefficient number higher than 1.30 (ex. 1.40)
FOB
Detector : On
Flow rate x 1.30
FOB
Warning!
On : Push Start
Off : Push Stop
11
