SETUP Mode
When users install ReverseTap dispenser for the first time, this mode must be executed.
By executing this mode, the dispenser can measure and memorize the flow rate of the
beer during dispensing. Memorizing the flow rate is important because it will enable FOB
mode to work properly. This mode should be executed every time when there is a change
of system environment such as change of cooling machine, change of CO2 pressure rate,
and change of beer brand.
• Once entered into this mode, plug the cup into the dispenser
• Double press the Start button to start dispensing the beer
• Press Stop button to finish the discharge of beer when it reaches any desired amount.
• Long press the Set button, and then the discharged amount will be automatically set as
the preset size of Medium.
• If you want to change the amount of each preset size, you can change it in Size-setting
Mode
• Pressing any other button will take you back to the initial screen of Sync Mode without
saving.
SETUP
Push Start
Size-setting Mode
In this mode, users can change and set the discharge amount of each preset size
(Small/Medium/Large)
• Once entered into this mode, you can press Up and Down button to select any of the
three preset sizes (Small/Medium/Large)
• Once you chose any preset size, you can press Set button. Then the numbers below
will start blinking. Now you can change the numbers to set the discharge amount of
preset size using Up and Down button.
Small
12.2 oz
10
