Chapter 7 Operation
7.1 Skills of pressing and writing
Single-click & Double-click:
Do not raise the electronic pen or writing pen (finger)
too much (about 1-2mm from the tip to the surface), keep the angle between pen and
surface more than 50º, then press the surface at proper strength. The operation of
double-click on board has the same definition as double-click mouse in Windows,
please make sure you click at the same point.
Drag:
Use the electronic pen or writing pen (finger) to press an item and drag it to the
appointed position (during which the pen tip or finger tip should not leave the surface)
Write:
If you use IQBoard Software, you can use the drawing tools to directly write on
the surface. (The writing strength should be the same as using the normal whiteboard
pen.)
Orient:
If the pressing position does not match the cursor, please re-orient. If the
deviation still exists, please check the installation of the whiteboard.
Right-click:
Click the surface and hold for 2 seconds to popup the right-key menu.
(IQBoard Software also provides this function. Refer to IQBoard Software User
Manual for details).
7.2 Hotkeys
Note:
1. Please use the 1024*768 resolution. Close all energy saving modes to avoid
performance delay caused by dormancy.
2. To lengthen life span of the battery, please take it out if you will not use the electronic
pen for a long time.
