Chapter 6 Orientation and Hotkey Setting
6.1 Orientation
At the first time you use the whiteboard, you need to orient it, so the moving track of
the electronic pen or writing pen (finger) can match the cursor. You can select 4 points,
9 points or 20 points orientation. Normally 9 points orientation is adopted. After the
whiteboard is oriented, you don’t need to re-orient at the same environment.
Operation steps are as follows:
Step 1. Select
“Start > Programs > IQBoard ET & PS Drivers >Orient”
to enter the
Orient Precision Selection window, as follows. If your product model is without H, N
and T, you also can press “
” in the hotkey bar.
Step 2. Select Orientation Points and click
“Ok”
, the orientation interface will appear.
According to the arrows instruction, use electronic pen or writing pen (finger) to
press the green center of the flickering red “+” on the surface. If the cursor is on
the same point, this point is successfully oriented. And the next point appears. The
whole orientation process is simply using your signal pen to click each orientation
point in sequence.