Renova isomatic, User Manual

Page: 5 / 28

5
warnings and safety aspects
The control system has been designed in compliance to CE regulations. Additionally, the tension control system
isomatic is designed to work in harsh industrial environments.
Before proceed to the installation and during the utilization of the system, check the following points:

Danger: Disconnect all the power connections before installing the system and remember to provide a
solid ground connection.

Danger: Never open the cover of the tension control’s electronic parts when the power is switched on or
when the system is working. Do not manage or disassembly the system.

Danger: Do not touch the electrical connections with wet hands

Do not use the control system in a potentially explosive environment. Use this system only in fire-proof
and explosion-proof environments.

Danger: use only the power and connection cables supplied together with the system. Please, replace the
eventual damaged cable immediately.

Danger: use power cable that can deliver the required amount of current.

Attention: in case of incorrect operations due to EMC interferences, separate the power cables from the
signal cables.

Attention: do not install the system in a position subjected to conductive powder or to corrosive gases. Do
not expose the system to high temperature, wind, vibrations and environments subjected to bad weather.

Attention: Renova is not responsible for any damage caused by repair, modifications or tampering of the
system, done by a third party and not authorized by Renova.

Attention: the above-mentioned directives are subjected to changes without prior notice.
installation of the tension control system
SUPPLIED MATERIAL
The isomatic tension control system includes:
- 1x LCD user interface with keyboard ( dim. 124x104x65mm – cut-out 90x90mm )
- 1x or 2x load cells
- 1x brake for tension correction with connection cables (optional)
- 1x power supply box with connection cables (optional)
INSTALLATION DRAWINGS
The mechanical dimensions are reported on drawing isomatic/mechanical dimensions, 41M052E
The electrical connections are reported on drawings isomatic/electrical connections, 42E004E