Before going on you should first verify that the
correct measurement system is being used
(feet or meters). The default measurement sys-
tem is feet but you may want to use meters.
To check or change the setting, select
Preferences from the Options pull down menu
in the tool bar section of RHAON or right click
in the center of the beam steering window.
If you want to change from feet to meters, click
in the Metric radio button.
Note that this window also allows you to control
the behavior of the Fault Relay and the Power-
On sequencing delay.
The Beam Steering tab contains the setting
controls for the appearance of the Beam
Steering window. The normal default setting are
shown.
Notice that this setup window also allows you to
change the height of the measuring plane (the
Ear Height
). Until you are more familiar with
the program we suggest you accept the default
setting. There are times, however, when you
will want to change the height of the measuring
plane. It is set to 1.2 meters (3.94 feet) which is
fine for a seated audience, but not for a stand-
ing audience.
The Mapping Appearance section allows you to
control the appearance of the main Mapping
plot. For now, we suggest using the default set-
tings. You can experiment with various settings
later.
The Scale Level Views section gives you con-
trol over the scales used in the main Mapping
window.
Many experienced users like to use the
Fixed
Range
option under
Scale Level Views
; setting
the
Round Up
to 5 and the
Show Range
to 5.
You may want to experiment with this to see
which settings you like best.
We’ll investigate the other tabs later.
25
C
O
N
N
E
C
T
M
O
D
E
Users Manual
IC-R
