43
• This completes the general commissioning of the projection radio alarm clock.
You can operate the projection radio alarm clock without the plug-in mains
adapter this way. However, the display will only be lit and the projection
switched on when the button “
SNOOZE/LIGHT
” (
B5
) is pushed. This lasts
about 5 seconds.
c) Connecting a plug-in mains adapter
After the power adapter is attached the display is lit permanently and perma-
nent projection is achieved.
When acquiring a plug-in mains adapter, pay attention to the technical data. It must
provide an output voltage of 4.5 V/DC at 200 mA. The output plug must have an outer
diameter of 3.5 mm and an inner diameter of 1.5 mm.
• Connect the output of the plug-in mains adapter to the intended socket
B12
at the rear
of the projection radio alarm clock.
• Now plug the mains adapter into a mains socket.
Both permanent display illumination and permanent projection are now ena-
bled.
• To enable permanent projection, slide the switch
B9
on the back to position “
ON
” (to
the left).
• To enable permanent display illumination, slide the switch
B10
on the back to position
“
ON
” (to the left).
• When one of the two functions is deactivated, it can still be activated for 5 seconds
with the button “
SNOOZE / LIGHT
” (
B5
).
Summary of Contents for 1423362
