0
Installation procedure
Figure 5 -
Mounting the PI 200 adjacent to the Renishaw PHC10-2
Remove the blanking plugs from the sides of each unit. Separate the halves of the link
bracket and screw them to the interface/controller units, using the M5 x 6 mm long
screws provided. Bring the units together and screw the brackets together. Screw the
rack mounting brackets to the free ends of each unit and assemble into the equipment
rack.
.2 Mounting with older style Renishaw control units
To fit the PI 200 into an existing installation adjacent to an older style PHC10 or ACC2
(with extruded aluminium side panels), a link bracket (part no. M-1018-0097) and 2 ×
M5 × 6 mm long screws (part no. P-SC29-0506) are required.
Remove the blanking plugs from the sides of the PI 200 and screw the bracket in place.
On the older style enclosure, prise out the rubber cover from the corner moulding
and loosen the two screws at the top and bottom of the moulding. Locate the bracket
between the corner moulding and the unit’s front panel, tighten the screws and replace
the rubber cover. Fit the rack mounting bracket to the other end of the PI 200 and
assemble into the equipment rack.
