R11UM0156EJ0240 Rev.2.40
Page 12 of 82
Jul. 28, 2020
PRIME v1.4 Base Node Tool
User Manual
Renesas Electronics Group Confidential
3
.
PC Tool operation procedure
PRELIMINARY
Notice This is not a final specification. Some
parametric limits are Subject to change.
3. PC Tool operation procedure
3.1
G-CPX3 board setting
In this section, the settings for G-CPX3 board is described.
-
Choose Filter board. G-type RX band pass filter board should be chosen for only v1.4 using Global
mode (Ch.1, Ch.2, ... Ch.8, FULL, FCC or ARIB). A-type RX band pass filter board should be
chosen for v1.3.6 and v1.4 using only CENELEC-A mode.
-
Set JP3 to short when G-type filter board is chosen. Set to open when A-type filter board is chosen.
-
Set JP1 to RX (1-3, 2-4) side, JP2 as shown in Table 3-1, JP3 to short, JP6/JP7 to short.
-
Set SW1 all OFF, SW2 to Function side, SW3 to Default side and SW5 to USE RX side for all filter
types
-
Choose a boot mode to use about JP5. (Open: UART boot)
Table 3-1 G-CPX3 board setting
Board type
RTK0EE0003D01001BJ
RTK0EE0003D03001BJ
mode
Global mode
(v1.4 only)
CENELEC-A mode
(v1.4 / v1.3.6)
Global mode
(v1.4 only)
CENELEC-A mode
(v1.4 / v1.3.6)
Filter
G-type
A-type
G-type
A-type
JP1
RX (1-3,2-4) side
JP2
15V (3-4) side
12V (1-2) side
JP3
short
open
short
open
JP5
open: UART boot
JP6
short
JP7
short
SW1
all OFF
SW2
Function side
SW3
Default side
SW5
USE RX side
