7 Windows/Dialogs
ATTENTION
•
The RAM monitor window shows the data that have been accessed through the bus. Therefore,
changes are not reflected in the displayed data unless they have been accessed via the target
program as in the case where memory is rewritten directly from an external I/O.
•
If the data in the RAM monitor area are displayed in lengths other than the byte, it is possible
that the data will have different memory access attributes in byte units. If bytes in one data have
a different access attribute as in this case, those data are enclosed in parentheses when displayed
in the window. In that case, the background color shows the access attribute of the first byte of
the data.
•
The displayed access attributes are initialized by downloading the target program.
•
The interval time at which intervals the display is updated may be longer than the specified
interval depending on the operating condition (shown below).
-
Host machine performance/load condition
-
Communication interface
-
Window size (memory display range) or the number of windows displayed
85
Summary of Contents for Emulator Debugger M16C PC4701
