Renesas Emulator Debugger M16C PC4701, User Manual

Page: 279 / 296

12 Attention
265
12.1.4 Function name in C++
• When you input the address using the function name in setting display address, setting break
points, and so on, you can not specify the member function, operator function, and overloaded
function, of a class.
• You can not use function names for C/C++ expression
• No script commands (e.g., breakin and func) can be used in which function names are specified
for arguments.
• In address value specifying columns of dialog boxes, no addresses can be specified using function
names.
• The pointers for a member function can not be referred correctly in C watch window.
12.1.5 Option settings for download modules
These options, which can be set in "Debug Settings" dialog box, are invalid for this debugger:
• Offset : specified value is regarded as ‘0’
• Access size : specified value is regarded as ‘1’
• Perform memory verify during download : Not supported.
12.1.6 Debugging multi modules
If you register two or more absolute module file in one session, you can download only one file in same
time.
If you register one absolute module file and one or more machine language file in one session, you can
download all file in same time.
12.1.7 Synchronized debugging
Synchronized debugging function is not available.
12.1.8 Down-load of Firmware
To start the debugger, a firmware corresponding to the connected emulation pod or emulation probe
must be downloaded to the emulator.
• The emulation pod or emulation probe has been changed.
• A unknown firmware is downloaded to the emulator.
• The debugger is used for the first time.
• The debugger has been upgraded.
In one of the above cases, you must perform the following operation before starting the debugger.
Press the emulator system reset switch within 2 seconds after turning ON the emulator power switch.
Then, the emulator enters a mode in which the firmware is forced to be downloaded.