( 62 / 68 )
6.2 When the M37641T2-RPD-E Does Not Work Properly
If your M37641-RPD-E does not operate normally, check the following. Go to (1) when your
M37641-RPD-E is connected to the target system, and go to (2) when it is not connected.
(1) YES, connected.
Check whether PC4701 and M37641-RPD-E are connected properly via the 120-pin flexible
cable. For more details, refer to "3.6 Connecting the PC4701 and Emulation Pod" (page 34).
Check whether the switches of the emulation pod are properly set. For more details, refer to "3.3
Switch Settings" (page 26).
Check whether the MCU file is properly set.
Check whether the mapping information is properly set. The initial settings of map areas are
as shown below.
• 00000h - 03FFFh: EXT
• 04000h - 0FFFFh: INT
• 10000h - 1FFFFh: INT
Check whether the proper oscillator circuit board is installed according to the current operating
voltage. For more details, refer to "5.1 Specifications" (page 46).
Check whether power (within the MCU's specified range and +3.0 to 3.6 V or +4.5 to 5.25 V)
and GND are supplied to the target system.
If an oscillator circuit on the target system is used, check whether it is oscillating properly.
Check whether pin RESET* is held High.
Check whether pin HOLD* is held High.
Check whether pin RDY* is held High.
(2) NO, not connected.
Check whether PC4701 and M37641-RPD-E are connected properly via the 120-pin flexible
cable. For more details, refer to "3.6 Connecting the PC4701 and Emulation Pod" (page 34).
Check whether the switches of the emulation pod are properly set. For more details, refer to "3.3
Switch Settings" (page 26).
Check whether the MCU file is properly set.
Check whether the mapping information is properly set. The initial settings of map areas are
as shown below.
• 00000h - 03FFFh: EXT
• 04000h - 0FFFFh: INT
• 10000h - 1FFFFh: INT
Check whether the proper oscillator circuit board is installed according to the current operating
voltage. For more details, refer to "5.1 Specifications" (page 46).
Summary of Contents for Emulation Pod M37641T2-RPD-E
