Jaune
Noir
Noir texte
1.29
ENG_UD46494_6
Sécurité enfants : installation du siège enfant (X92 - Renault)
CHILD SAFETY: fitting a child seat
(2/8)
In the rear side seat
A carrycot can be installed across the
vehicle and will take up at least two
seats. Position the child with his or her
feet nearest the door.
Before fitting a child seat to the ISOFIX
anchorages on the rear side seat,
ensure that the seat belt buckles are
not positioned between the two ISOFIX
anchorages on this seat. If necessary,
move the buckle from the seat in ques-
tion towards the centre of the vehicle.
Move the front seat as far forward as
possible to install a rear-facing child
seat, then move back the seat in front
as far as it will go, although without al-
lowing it to come into contact with the
child seat.
For the safety of the child in the for-
ward-facing seat, do not move the seat
in front back past the middle of the
runner, do not tilt the seatback too far
(maximum of 25° ) and raise the seat as
much as possible.
Check that the forward-facing child seat
is resting against the back of the vehi-
cle seat and that the headrest of the ve-
hicle is not obstructing its use.
Rear centre seat
A child seat may only be fitted in this
seat if it is equipped with an inertia-reel
seat belt. For any additional informa-
tion, contact an approved dealer.
Ensure that the child seat
or the child’s feet do not
prevent the front seat from
locking correctly. Refer to
the information on the “Front seats”
in Section 1 or “Rear seat operation”
in Section 3.
When fitting a child seat
(Group 2 or 3 booster seat),
check that the seat belts op-
erate (wind) correctly: refer
to Section 1 “Rear seat belts”. If
necessary, adjust the position of the
vehicle seat.
A child seat with a floor
support must never be in-
stalled on the rear centre
seat.
RISK OF DEATH OR
SERIOUS INJURY
.
