REMKO MXV 200, Operation,Technology,Spare Parts

Page: 5 / 28

Stop valve
Mains cable
The equipment is shipped in sturdy
transport packaging. Immediately
check the equipment on delivery
and make a note of any damage or
missing parts on the delivery note.
Inform the forwarding agent and
contractual partner.
Warranty claims at a later date will
not be accepted.
Description of the
equipment
Transport and
packaging
The indoor unit on the split-design
combined room air conditioning
units serves to extract heat from
the indoor room being cooled. The
outdoor unit then expels this heat
to the outside.
If combined heating/cooling units
are operated as heaters, the heat
absorbed by the outdoor unit can
be discharged by the indoor unit
into the room being heated.
The unit is designed for installation
high up on indoor walls.
It is operated via an infrared
remote control.
The indoor unit consists of a fin
vaporiser, vaporiser fan, regulation
system and condensation pan. The
indoor unit can be combined with
REMKO outdoor units of series
MVT 600/900/950/1050 DC
with sufficient cooling output. The
outdoor unit is controlled via the
regulation of the indoor unit.
Condensation pumps are available
as an accessory.
Schematic of refrigerant circuit
Vaporiser fan
Connection to
suction pipe
Connection
Injection pipe
Vaporiser
Refrigerant pipes are used to
connect the indoor unit to the
outdoor unit.
Outdoor
unit
System layout
Liquefier fan
Outdoor area
Injection pipe
Suction pipe
Control line
Condensation line
Indoor area
Condensation line
Indoor unit
Intended use
Depending on the model, the
equipment and the additional
fittings with which it is equipped
is only intended to be used as an
air-conditioner for the purpose of
cooling or heating the air in an
enclosed room.
Different or additional use shall not
be classed as intended use. The
manufacturer/supplier assumes no
liability for damages arising from an
unintended use of the equipment.
The user bears the sole risk in such
cases.
Using the equipment as intended
also includes working in accord-
ance with the operating manual
and installation instructions and
complying with the maintenance
requirements.
5