Manual unit addressing
The MVV series outdoor units automatically assign
addresses to the indoor units during commis-
sioning. However, these can also be assigned
manually (for example, for arrangement on the
Multi-Central-Controller).
By pressing the key for longer than 5 seconds
the addressing mode of the IR remote control is
activated. The addressing mode can be exited by
pressing the key again for longer than 5 sec-
onds.
1. Querying the unit address
If the addressing mode (see above) is active, the
signal transmission must be activated by pressing
the key. The key can then be used to query
the unit address. The address appears directly on
the display or is coded as an LED flashing code
(for ceiling cassettes).
2. Assigning the unit address
If the addressing mode (see above) is active, the
signal transmission must be activated by pressing
the key. Use the arrow keys to preselect
the desired address, then press the key to
transfer it to the unit.
REMKO MXV series
18
Summary of Contents for MVW 222
Page 39: ......
