4.2 Display on indoor unit
Display
2
1
4
3
5
Fig. 5: Display
1: Receiver infrared signal
2: Operating lamp (green)
3: Timer (yellow)
4: (Pre) heater function/defrosting (green)
5: Manual mode
4.3 Manual air distribution
Setting the air distribution
The vertical air control blades can be manually
moved to the left and right (s. Fig. 6). An automatic
swing function is also available for horizontal air
distribution (s. Chapter “Buttons on the remote
control”).
Fig. 6: Setting the air distribution
Setting of the air outlet
The air outlet on the device can be set for
improved comfort. The units can blow out air on
the top and bottom sides. Proceed as follows to
change the settings:
1.
Switch the unit off and open panel (s. Fig. 7)
2.
The switch to select the blow-out direction
can be found below the LED's (s. Fig. 8)
3.
If the switch is set to the symbol [A] (s. Fig. 8)
the indoor unit automatically determines the
blow-out side depending on the mode/situa-
tion (s. Table
).
4.
The unit only blows out the top side in the
operating mode “Dehumidify”.
5.
Switch the selector switch to position [B] to
stop the unit blowing out from the bottom
side (s. Fig. 8). The unit only now blows out
the top side, depending on which operating
mode is set. Be aware that the unit must be
switched off before the change can take
effect.
11
Summary of Contents for MVW 222
Page 39: ......
