REMKO KF 2, Operation Technology

Page: 4 / 20

4
REMKO KF
Carefully read the operating manual
before placing the unit in service for
the first time. It provides useful tips,
notes and hazard warnings to
prevent injury and material damage.
Failure to follow the directions in this
manual can endanger persons, the
environment and the equipment itself
and will void any claims for liability.
■
Keep this manual in the vicinity of
the units.
■
Only qualified personnel may set up
and install the units and components.
■
Set-up, connection, and operation
of the units and their components
must be done in accordance with
the operating conditions as specified
in this manual and comply with all
applicable local regulations.
■
Modification of the units and
components supplied by REMKO
is not permitted and can cause
malfunctions.
■
Units and components may not be
operated in areas where there is an
increased risk of damage. Observe
the minimum clearances.
■
The electrical power supply is to be
adapted to the requirements of the
units.
■
The operational safety of units and
components is only assured if they
are fully assembled and used as
intended.
Safety notes
Safety devices may not be modified
or bypassed.
■
Do not operate units or components
if there are obvious defects or signs
of damage.
■
The units and components must be
kept at an adequate distance from
flammable, explosive, combustible,
abrasive and dirty areas or
atmospheres.
■
Installation, repair and maintenance
work may only be carried out
by authorised specialists. Visual
inspections and cleaning can be
performed by the operator as long
as the unit is disconnected from the
power.
■
Take appropriate precautions when
performing installation, repair or
maintenance work or cleaning the
unit to make sure the unit does not
pose a danger to persons.
Intended use
Depending on the design and equipment,
the components are intended exclusively
for remotely operating indoor unit chillers
in the KWD 25 EC to 100 EC range.
Any different or additional use is a
non-intended use. The manufacturer/
supplier assumes no liability for damages
arising from non-intended use. The user
bears the sole risk in such cases.
Intended use also includes working
in accordance with the operating and
installation instructions and complying
with the maintenance requirements.