REMKO KF 2, Operation Technology

Page: 11 / 20

11
Network mode
This function can only be used with a master cabled remote control
(UNIT 01 in display). Network mode cannot be activated with slave
units. Press and hold the SLEEP key for more than 5 seconds to
activate network mode. The symbol is shown on the display.
All settings for network mode can now be made. These settings must
be confirmed with the ENTER key. Network mode will be cancelled
and the previous settings will be retained if confirmation is not made
within 8 seconds or the SLEEP key is pressed again. Refer to the
settings for network mode in the chapter entitled “Master/Slave
settings”.
Night increase/night decrease (sleep function)
By pressing the SLEEP and ENTER keys, the room temperature is
increased or decreased by 2 °C within 2 hours in cooling mode
and heating mode respectively. After a further 30 minutes, the
temperature is increased or decreased by 0.5 °C in cooling mode
and heating mode respectively. After a further 30 minutes, the room
temperature is raised or lowered by 0.5 °C in cooling and heating
mode respectively. After a further hour, the room temperature is raised
or lowered by 1 °C in cooling and heating mode respectively.
This temperature is now maintained at a constant level. This function
is ended by changing the operating mode, switching on/off or
pressing the SLEEP and ENTER keys again.
Sleep/
Network
Key
Deactivating the timer function
If already in the timer level, the activation of the set timers can
be cancelled by selecting the SET function. This must then be
acknowledged by pressing the ENTER key.