REMKO KF 2, Operation Technology

Page: 15 / 20

15
Notes for installing the internal network
All units must be connected to each other with an internal bus line.
In addition, the last unit, which is controlled via the cabled remote control, must be
marked via the jumper assignment of jumper JP1. The jumper on this unit must be set
to position JP1.
Programming
The slave units can only be programmed from the master unit via the network
function (SLEEP key). If the SLEEP key is pressed for more than 5 seconds, the
network symbol and UNIT ALL will appear on the display. Now the desired settings
can be made and the slave units can be selected with the TIME key. The settings can
either be transmitted to all slave units (UNIT ALL) or to a specific slave unit with a
pre-defined address (UNIT 02 to 31).
Transfer to all units (UNIT ALL)
Transfer to a unit (UNIT 02 to UNIT 32)
The settings are
transmitted to all
units.
Once the address of the units and other settings have been selected, always press the
ENTER key to transmit the settings.
Notes for operating the internal network
■
The timer function can only be programmed individually on each unit. The timer
function cannot be transmitted to all units via the master remote control.
■
When the settings are transmitted to all units (only via the master remote control),
the settings are also adopted by the master unit. The individual settings of the
master unit can only be changed after they have been transmitted to all units.
■
If the timer function of a master remote control is activated, network mode
cannot be activated with the SLEEP key to make changes.