Usage Tips
8
Charging
Prior to using your shaver for the first
time, put it on charge for 24 hours.
To charge your shaver:
■
Make sure your shaver is turned off.
■
Connect the cord to the shaver and
then the charging adapter to the
electric outlet. A charging indicator
light will come on.
■
Your shaver cannot be overcharged,
so you can leave it plugged in and
charging between shaves.
■
Use only the charging adapter
supplied with the shaver.
■
R-650s:
Special feature allows you
to run the shaver directly off the
cord. Your shaver will not recharge
while you are shaving, so after
shaving directly from the cord, turn
the unit off and set aside to charge.
Model R-450s/650s
A green indicator light shows when the
shaver is charging.
Troubleshooting:
■
If your shaver battery is completely
dis-charged or the shaver has not
been used for an extended period
of time, the shaver may not start
when operated using the cord.
If this condition occurs, charge
the shaver for approximately five
minutes before shaving.
■
Your cord/cordless shaver should
not be used strictly as a cord-
operated shaver, as continued cord
only use will result in reduction of
battery life.
■
In order to preserve the life of
the batteries, they should be fully
discharged every six months and
then fully charged for 24 hours.
Worldwide Voltage
(R-650s Microflex
®
Model)
You can take your shaver with
you when you travel to just about
anywhere in the world. Your shaver
features worldwide automatic dual
voltage conversion providing AC
current between 100-240 volts AC,
50-60 Hz. Just plug it in to the local
outlet (you may need an adapter
plug) and use as usual. Your shaver
will convert automatically to the local
current requirements.
Battery Removal:
When your rechargeable shaver
reaches the end of its useful life, the
batteries must be removed from the
shaver and be recycled or disposed
of properly in accordance with your
state and local requirements.
9
THE FOLLOWING PROCEDURE
SHOULD BE FOLLOWED FOR
BATTERY REMOVAL:
■
To avoid a
possible electric
shock hazard,
unplug cord from
electric outlet
and shaver.
■
Open the head
assembly by
pressing the head
release buttons
and lifting the
head assembly.
Pull the entire
head assembly
off of the shaver
assembly.
■
Push the
trimmer button
up to open the
trimmer.
■
Remove
the trimmer
assembly by
squeezing the
sides as shown
in the picture.
■
Using a small Phillips head
screwdriver, remove the 3 screws
from the back of the shaver.
■
Pull or gently pry the shaver halves
apart, exposing the battery.
■
Pry the lower battery clip off.
■
Lift or pry the batteries out of the shaver.
■
Cut the wires on both ends of
each battery and remove them
from the shaver.
CAUTION: DO NOT PUT IN FIRE OR
MUTILATE YOUR BATTERIES WHEN
DISPOSING AS THEY MAY BURST
OR RELEASE TOXIC MATERIALS.
DO NOT SHORT CIRCUIT AS IT MAY
CAUSE BURNS. DISPOSE PROPERLY
IN ACCORDANCE WITH YOUR LOCAL
AND STATE REQUIREMENTS.
34159_R450S-650S_IB_update.indd 8-9
5/24/07 11:05:07 AM
